Magnetic Drill Press

Magnetic drill knowledge Before installing or removing the drill, make sure that the switch of the motor has been turned off and the has been removed. After using the drill clamp bit, the key wrench must be removed, and the Morse taper shank drill should be inserted into the cone ...Magnetic drill knowledge Before installing or removing the drill, make sure that the switch of the motor has been turned off and the has been removed. After using the drill clamp bit, the key wrench must be removed, and the Morse taper shank drill should be inserted into the cone sleeve.

The flat iron is inserted into the groove of the cone sleeve, and the drill bit is knocked off with a hammer. When switching on the power supply, the drill and the magnet switch must be in the disconnected position. With stepless speed regulation, constant power over load model, such as the motor stops running during the process, under the action of overload protector operation steps: a, turn off the power switch, stop for a few minutes; b, reinsert the power and turn on the motor.

Warning: magnetic drill with safety rope, operation, must be tightly tied safety rope magnetic drill and the drill object to fix, prevent sudden power failure, power failure, stuck drill caused by machine fall off.